#CHAMBERLAIN GARAGE KEYPAD PROGRAMMING HOW TO#

HomeLink is now in the training (or learning) mode and can be programmed at any time beginning with step 1 on how to program, explained above.Press and hold the two outer HomeLink buttons until the indicator light begins to flash If you are having trouble programming your HomeLink please contact them directly at 1-80 or To erase programming from all three buttons:ġ. Proceed to step 3 to complete the process. Now you may release both the HomeLink and hand-held transmitter buttons. Continue to press and hold the HomeLink button while you press and release your handheld transmitter every two seconds (“cycle”) until the HomeLink indicator light changes from a slow to a rapidly blinking light.*If you are having difficulties programming a gate operator or garage door opener by using the steps listed above, replace step 2 with the following instructions:

#CHAMBERLAIN GARAGE KEYPAD PROGRAMMING CODE#

Repeat the “press/hold/release” sequence a second time, and, depending on the brand of rolling code equipped device, repeat this sequence a third time to complete the programming process. Return to the vehicle and firmly press and hold for two seconds then release the programmed HomeLink button. You now have 30 seconds to begin step 6.Ħ. Firmly press and release the “learn” or “smart” button. The backlight is what lights up the keys, so you can see them at night. The easiest way to tell if your battery needs replacement is if the backlight is not shining. If your outside keypad is not working, the first thing you want to check is the battery. At the garage door opener receiver (motorhead unit) in the garage, locate the “learn” or “smart” button. This can usually be found where the hanging antenna wire is attached to the motorhead unit.ĥ. A 9V battery powers most outside keypads. If the indicator light blinks rapidly for two seconds and then turns to a constant light continue with “Programming” steps 4-6 to complete the programmingĤ.

If the indicator light stays on constantly, programming is complete and your device should activate when the HomeLink button is pressed and released.If the door does not activate, press and hold the just-trained HomeLink button and observe the indicator light: Firmly press, hold for five seconds and release the programmed HomeLink button, up to two separate times, to activate the door. Simultaneously press and hold both the chosen HomeLink and hand-held transmitter buttons until the HomeLink indicator light changes from a slow to a rapidly blinking light. Position the end of your hand-held transmitter 1–3 inches (5–14 cm) away from the HomeLink button you wish to program while watching the indicator light.Ģ. If your Volvo is equipped with the HomeLink system you will have the controls available located on the driver's side visor:ġ. The HomeLink Wireless Control System provides a convenient way to replace up to three hand-held radio-frequency (RF) transmitters that are used to activate devices such as gate operators, garage door openers, entry door locks, security systems, and home lighting.

Chamberlain garage keypad programming